彩鋼板表面防水是多方面的，大多數是工序之間忽視了防水，個人只顧在自己的工序段負責，不考慮工序的銜接。下面濟南防水介紹一下彩鋼板表面防水應該注意哪些問題？
1、排水，從瓦上、天窗、煙囪、排氣空、瓦的交角處查看排水是否流暢將積水排走。
Drainage from the tile, skylights, chimneys, exhaust air, tile drainage is smooth viewing angle at the water to drain away.
2、堵水，在輔設的防水層上面找出漏水點將防水層修補好把水堵住。
Shutoff, the waterproof layer on top of the auxiliary set point to find leaks and repaired water waterproof layer blocked.
3、引水，這是最下等的做法，也就是說在找不到漏水點的情況下才使用的一種辦法，將積聚在保溫層中的水引到外邊，將瓦退掉,砸開保護層、去掉防水層、找平層將露出的保溫層積水多的部位劃上記號再去掉保溫層并清理干凈。在清凈的混凝土板上找出漏水點，用防水寶材料堵住，然后大面作一道防水層，在有記號處設置排水口，然后回填找平。重心做防水處理，并要和原來的防水層搭接好，做好保護層將瓦裝好，清理好現場。
Water, which is the most inferior way, one way is to say in the case can not find the leak point was used to accumulate in the insulation layer of water to the outside, the tile drained away,broke down the protective layer, remove the waterproof layer, insulating layer and the exposed water screed, marks the site of more then remove insulation and clean. In clean the concrete slab to find the leakage point, with waterproof material treasure blocked, then Omo as a waterproof layer, there is provided at the outlet mark, then backfill leveling. Waterproof treatment center, and to
the original waterproof layer overlap, and do protective layer watt installed, cleaned up the scene.
